Product Categories
contact us

Jiangsu Lanming Environmental Protection Technology Co., Ltd. Tel: 0510-87018530
Fax: 0510-87018530
Mr. Zhou: 13506157228
Ms. Xu: 13921338925
Website: shoelessnz.com
Email: jslmhb5383@163.com
Address: Yuedong Road, Huankeyuan, Yixing City, Jiangsu Province

News Center
Five parts of the structure of the incinerator system
Hits: 1665 times Added: 2018-1-26 [ Print ] [ Return ] [ Favorite ]

The composition of the incinerator incineration system mainly includes: feed, combustion support system, incineration system, dust collector system, and electronic control system.

1.Feeding method Choose a reasonable feeding method according to various designs

2. The main equipment of the combustion-supporting system is a gas burner. The role of the combustion-supporting system is to open the furnace and incineration of auxiliary materials. Natural gas fuel and air are mixed and burned in the burner combustion head, and the best combustion can be obtained by adjusting the combustion air and the combustion head. Parameter, the recirculation of embers gas in the combustion head can minimize the emission of pollutants, especially nitrogen oxides (NOx). With full automatic management of combustion procedures, flame detection, automatic judgment and prompt fault functions. The burner can perform automatic ignition under the control of a program controller. The burner has the functions of automatic ignition, fire protection, fault alarm and so on. It has the characteristics of large flame intensity, stable combustion, good safety and large power adjustment. The burner can manually adjust the air flow to change the size of the flame; the built-in pressure regulating valve guarantees a stable outlet pressure; at the same time, the amount of gas can be adjusted by adjusting the supply pressure.

3. The incineration system is mainly the furnace body. The furnace body is a cavity that is built in the upper part of the grate with refractory materials, heat insulation materials and thermal insulation materials. The steel plate is outsourced to prevent smoke leakage and the surface temperature of the furnace body is less than 50 C. An inspection door is provided on the side of the furnace body, and an auxiliary ignition burner is also on the side. The furnace body is provided with an operation table.

4.Dust collector system

It is mainly a centrifugal dust collector to remove dust after incineration. The dust collection system consists of three parts: a dust collection cylinder, an inverted cone and an exhaust duct. The role of the dust collection system is to collect the particulate dust contained in the flue gas generated by the incineration material, which is convenient for centralized cleaning. At the same time, it can reduce the pollution to the atmosphere and purify the environment.
Working principle of the dust collection system: The particulate dust contained in the flue gas generated by the incineration material reaches the cyclone dust collector under the powerful suction of the induced draft fan. Cyclone dust collector is a device that uses the principle of centrifugal landing to separate particulate dust from the air stream. The upper part of the cyclone duster is conical. When the dust-containing gas enters from the tangential direction of the intake pipe on the upper side of the cylinder, it obtains the rotation reverse motion. After the dust is separated, it is discharged from the exhaust pipe at the top of the cylinder. The dust particles Drop from the cone bottom into the dust collecting cylinder.

5.Electrical control system power distribution cabinet includes: the main power supply of the complete set of equipment, the sub-power supply control switch of a single piece of equipment; the start-stop control of the complete set of equipment and a single piece of equipment, as well as the protection circuit, alarm, etc .; the operation panel. Some of these devices are set on-site for the convenience of operation and observation.